Live Chat | 8:00AM – 5:00PM EST | We ship worldwide!

Nozzle Magazine


Fully assembled and tested nozzle magazine capable of holding 10-20 JukiTM nozzles and mounts to a 2020 aluminum extrusion. Works great with our quick change nozzle holders. Available in two sizes medium (10 nozzles) and large (20 nozzles) for use with OpenPNP.

This nozzle magazine system is better than the “ramp up” 3D printed designs out there because it exerts no force or friction on the nozzle holder, ensuring your nozzle holders don’t lose their calibration (X/Y offsets). This design also saves you space in X/Y. Nozzles are locked quickly with the 90N20 motor. Uses two limit switches to detect open/close. Alternatively you can wire it to a single limit switch and just run it that way to save a pin. Motor is 5v DC.

Wire harness sold separately here.

Nozzle Magazine



Setup instructions available here.

Juki is a trademark of Juki Corporation and not affiliated with Deltaprintr.

Additional information

Weight2 lbs
Dimensions18.5 × 1.1 × 1.1 in

medium, large